WatchGuard XTM 2 wird warm

Die aktuellen WatchGuard XTM 21, XTM 22 und XTM 23 Appliances werden im laufenden Betrieb recht warm. Einige Kunden sorgen sich daher über die dauerhafte Zuverlässigkeit. Ich darf folgendes Original-Zitat des PM wiedergeben:

“The 2 Series enjoys a more powerful set of components than were available at the time of Edge development. These components produce more heat that must be dissipated out the 2 Series case. Part of the design of the case is to use the bottom plate as a heat sink, in order to move the heat away from critical components. As such, the user may sense that the bottom plate, or the case overall, is warm or hot to the touch. This is expected, and even desirable to keep the product running in optimal fashion for the entire product life. It is within specifications for this device, and a similar heat output to many laptop computers and power supplies sold into consumer markets.
There is actually a KB article on the 2-Series wireless ‘heat’. Also in the wireless version, we’ve put more powerful, heat producing components in this design as compared with Edge, and we use the bottom plate as a heat sink, which actually siphons the heat away from the sensitive components and keeps your equipment running properly. You know it’s doing its job if it’s warm. Also, it’s been tested many times and is within engineering tolerance.”

Laut WatchGuard ist die Wärmeentwicklung also kein Grund zur Besorgnis. Ich empfehle jedoch darauf zu achten, dass die Wärmeabfuhr über die Unterseite des Geräts nicht behindert wird: Stellen Sie die XTM 2 NICHT oben auf ein anderes Gerät, das ebenfalls warm wird wie z.B. ein DSL-Modem oder einen DSL-Router. Wenn die XTM 2 in einem sehr kleinen abgeschlossenen Gehäuse oder Schrank betrieben werden soll, prüfen Sie bitte ob auch die Wärmeabfuhr aus diesem Schrank heraus gewährleistet wird. Und schützen Sie das Gerät vor direkter Sonneneinstrahlung, die das Gerät nur zusätzlich aufheizen würde…

Leave a Reply

Your email address will not be published. Required fields are marked *